Maynard A. Philbrook Jr. wrote:> In article <co17q9lhfcu0g0l148ahgbq39lrsulfnpo@4ax.com>, > jlarkin@highlandtechnology.com says... >>> circle click on it aagin while the cursor is on the circle, then you can >>> do the two end points. The radius has to be set before when you place >>> the elipse (which vanishes after the 2nd click). >>> >>> But arcs are not a desired thing in electronics ... >> I wanted to draw some nice gaussian looking pulses on my schematic >> here and there. I finally got it to work by clicking a lot, but I >> don't think I really get it. I suppose I should have just used a >> zillion line segments. >> >> The HELP says, basically >> >> ARC : use the ARC tool to draw an arc. >> >> > A Polyline function would be nice ) >At first glance I subconsciously read "Pauline function" :-) http://www.mariowiki.com/Pauline -- Regards, Joerg http://www.analogconsultants.com/
LT Spice arcs
Started by ●June 19, 2014
Reply by ●June 21, 20142014-06-21
Reply by ●June 21, 20142014-06-21
On Fri, 20 Jun 2014 21:01:51 -0400, "Maynard A. Philbrook Jr." <jamie_ka1lpa@charter.net> wrote:>In article <co17q9lhfcu0g0l148ahgbq39lrsulfnpo@4ax.com>, >jlarkin@highlandtechnology.com says... >> >circle click on it aagin while the cursor is on the circle, then you can >> >do the two end points. The radius has to be set before when you place >> >the elipse (which vanishes after the 2nd click). >> > >> >But arcs are not a desired thing in electronics ... >> >> I wanted to draw some nice gaussian looking pulses on my schematic >> here and there. I finally got it to work by clicking a lot, but I >> don't think I really get it. I suppose I should have just used a >> zillion line segments. >> >> The HELP says, basically >> >> ARC : use the ARC tool to draw an arc. >> >> > A Polyline function would be nice ) > >JamiePADS had a "pull arc" function. Click on any line segment and bend it as much as you like in either direction. The LT Spice drawing functions are primitive, but the price is right. -- John Larkin Highland Technology Inc www.highlandtechnology.com jlarkin at highlandtechnology dot com Precision electronic instrumentation
Reply by ●June 21, 20142014-06-21
In article <c0lj7lFi9nrU1@mid.individual.net>, invalid@invalid.invalid says...> > Maynard A. Philbrook Jr. wrote: > > In article <co17q9lhfcu0g0l148ahgbq39lrsulfnpo@4ax.com>, > > jlarkin@highlandtechnology.com says... > >>> circle click on it aagin while the cursor is on the circle, then you can > >>> do the two end points. The radius has to be set before when you place > >>> the elipse (which vanishes after the 2nd click). > >>> > >>> But arcs are not a desired thing in electronics ... > >> I wanted to draw some nice gaussian looking pulses on my schematic > >> here and there. I finally got it to work by clicking a lot, but I > >> don't think I really get it. I suppose I should have just used a > >> zillion line segments. > >> > >> The HELP says, basically > >> > >> ARC : use the ARC tool to draw an arc. > >> > >> > > A Polyline function would be nice ) > > > > At first glance I subconsciously read "Pauline function" :-) > > http://www.mariowiki.com/PaulineYou get into some strange stuff! :) Jamie