HP3586 Selective Voltmeter Help

I bought an HP3596B off Ebay.
  I have a service manual on order.
  First thing I did was remove the leaky battery and thoroughly clean 
the PS board.
It looks good, however if I look down to the edge connector inside the 
unit I can see it has the blue buildup on it from the battery leak. I'll 
save that until I disassemble to clean and lube the switches.

  At power up the self calibration comes back with CE-F.
One poster suggested I put in  Recall, Decimal point, Center Frequency 
,8, when I do that comes back with
Fail  1  0.
  Anyone have info on what the error codes denote?

                                 Mikek

   It's an HP 3586B, mis-typed below.

On 10/19/2017 10:22 AM, amdx wrote:
> I bought an HP3596B off Ebay.
>   I have a service manual on order.
>   First thing I did was remove the leaky battery and thoroughly clean 
> the PS board.
> It looks good, however if I look down to the edge connector inside the 
> unit I can see it has the blue buildup on it from the battery leak. I'll 
> save that until I disassemble to clean and lube the switches.
> 
>   At power up the self calibration comes back with CE-F.
> One poster suggested I put in  Recall, Decimal point, Center Frequency 
> ,8, when I do that comes back with
> Fail  1  0.
>   Anyone have info on what the error codes denote?
> 
>                                  Mikek