John Larkin <jlarkin@highlandSNIPMEtechnology.com> wrote:
> Not everyone may know this one.
> 
> Given a series string of unconnected parts, you can select the wire
> tool, the pencil icon, and draw one long line through all the parts to
> do the connections. You can even turn corners. 
> 
> 

There&rsquo;s a control panel setting to turn that behavior off, ie to allow
straight line connections between pins. 

-- 
Dr Philip C D Hobbs  Principal Consultant  ElectroOptical Innovations LLC /
Hobbs ElectroOptics  Optics, Electro-optics, Photonics, Analog Electronics 

On Sunday, July 2, 2023 at 12:40:50 AM UTC+10, John Larkin wrote:
> Not everyone may know this one. 
> 
> Given a series string of unconnected parts, you can select the wire 
> tool, the pencil icon, and draw one long line through all the parts to 
> do the connections. You can even turn corners.

John Larkin has been going to too many Trump supporter rallies. The "not everyone" who doesn't know this must be a rather small proportion of the LT Spice users.

Flyguy probably wouldn't, but he doesn't seem to use LT Spice either. For somebody who posts to an electronic design user group, he  posts very little about electronic design - absolutely nothing that I can recall.

John Larkin isn't much better - he does post about electronics, but nothing about designing circuits. It is more about blowing up components.

-- 
Bill Sloman, Sydney

lørdag den 1. juli 2023 kl. 16.40.50 UTC+2 skrev John Larkin:
> Not everyone may know this one. 
> 
> Given a series string of unconnected parts, you can select the wire 
> tool, the pencil icon, and draw one long line through all the parts to 
> do the connections. You can even turn corners.

you can also place a part on a wire

Not everyone may know this one.

Given a series string of unconnected parts, you can select the wire
tool, the pencil icon, and draw one long line through all the parts to
do the connections. You can even turn corners.