Forums
Hello,Recently I built a tube pre-amplifier according to the Elector magazine from the late 1980's. It took me a while to collect all the necessary parts according...
You may already know that I will be going live at 1pm EDT today (03/29). Chances are you've already lowered your expectations.
Let's use this thread for communicating...
When I was a kid collecting broken radios to disassemble for parts, I encountered old single-loudspeaker radios that had four wires going to the loudspeaker. So...
Live Streaming from Embedded World Discussion Thread

This is the place where I hope to read your feedback and interact with you during the day as I do my best to live stream as much content as possible from Embedded...
If you tried to access one of the *Related sites today, you were probably greeted with something like:This site can’t be reachedThe *Related sites have been hosted...
I recently purchased a set of NI-MH batteries online for their long lasting power, and so far they serve me well.
In one order, I have received a free battery charger...
Trying to make the simplest VPP voltage switch for micros

I'm trying to make myself the proper voltages for VPP output using the fewest number of parts that are readily available in store (particularly from sayal electronics...
A few months ago, this community tackled the first FPGA FAQ titled When (and why) is it a good idea to use an FPGA in your embedded system design?. Your contributions...
Hi, I have to mix two signals and then split the mixed signals as shown in the following diagram: I have JFW 50PD-293 which I want to use as "Mixer" and Mini...
Operate microcontroller with safety circuit constrains

Hi all,I am required to design a circuit which regulate the voltage (3.3v) coming for a Master microcontroller pin to not more than 3v and restrict the current...
Registering will allow you to participate to the forums on ALL the related sites and give you access to all pdf downloads.