Sign in

username:

password:



Not a member?

Search Sci.Electronics.Design



Search tips

design by Keywords

8051 | Amplifier | AVR | CMOS | Converter | DAC | Diode | FPGA | GPS | I2C | IDE | Laser | LCD | MOSFET | Op-amp | Oscillator | Oscilloscope | PID | PLL | PSU | PWM | RFID | RS232 | RS485 | SMPS | Spice | Transformer | Transistor | TTL | USB | VCO

Ads

See Also

DSPEmbedded SystemsFPGA

design | LCD pin pitch ?


There are 4 messages in this thread.

You are currently looking at messages 0 to 4.

LCD pin pitch ? - Robert - 2008-07-09 14:53:00

Hello everyone,

I am working a a project that will probably use a custom LCD with through hole pins.  An LCD house has 
not been selected.  I am trying to educate myself before hand.

What are common values for through hole pin pitch, finer than 0.1"

Thanks
Robert



Re: LCD pin pitch ? - Eeyore - 2008-07-10 02:24:00


Robert wrote:

> Hello everyone,
>
> I am working a a project that will probably use a custom LCD with through hole pins.  An LCD house has
> not been selected.  I am trying to educate myself before hand.
>
> What are common values for through hole pin pitch, finer than 0.1"

Think of any number.

Graham

Re: LCD pin pitch ? - Mike Harrison - 2008-07-10 04:47:00

On Thu, 10 Jul 2008 07:24:39 +0100, Eeyore <r...@hotmail.com> wrote:

>
>
>Robert wrote:
>
>> Hello everyone,
>>
>> I am working a a project that will probably use a custom LCD with through hole pins.  An LCD house has
>> not been selected.  I am trying to educate myself before hand.
>>
>> What are common values for through hole pin pitch, finer than 0.1"
>
>Think of any number.
>
>Graham

The pins come in pre-formed strips, so there will be standard pitches - ask prospective LCD houses
what pitches are available.

Re: LCD pin pitch ? - linnix - 2008-07-10 06:37:00


Robert wrote:
> Hello everyone,
>
> I am working a a project that will probably use a custom LCD with through hole pins.  An LCD house has
> not been selected.  I am trying to educate myself before hand.
>
> What are common values for through hole pin pitch, finer than 0.1"

0.1" (2.54mm) and 2mm are the most commonly used.

>
> Thanks
> Robert